In this study was assessed the degree of conversion (DC) of amine-free resin cements light cured through lithium disilicate-reinforced ceramics at different thicknesses and translucency. Specimens were divided into 21 groups (n = 5) according to luting agent used: Variolink Esthetic LC (Light shade), RelyX Ultimate (A1 shade), and Filtek Z350 XT Flow (A1 shade); the ceramic translucency: low (LT) and high (HT); and the ceramic thickness: no ceramic (control), 0.5 mm, 1 mm, and 2 mm. A Teflon mold with (5 x 5 x 0.5 mm) was used to standardize the cement and over it the ceramic block from each group was placed. Set was cured using a polywave LED light (1200 mW/cm2 - Bluephase G2) for 40 s. FTIR spectra of uncured and cured materials was obtained and DC calculated from the height of the peaks 1610 and 1640 cm-1. Data were submitted to ANOVA followed by Tukey?s test (? = 0.05). There was a significant difference for luting agents (p< 0.0001) and translucency (p = 0.025), but not for thickness (p = 0.73). Dual amine-free RelyX Ultimate showed the lowest DC values and higher translucency promoted higher DC. Dual amine-free cement showed the lowest monomer conversion and higher translucency ceramics promoted a higher DC.