The coefficient of thermal expansion (CTE), biaxial modulus, and stress of some amorphous semiconductors(a-Si:H, a-C:H, a-Ge:H, anda-GeC x :H) and metallic (Ag and Al) thin films were studied. The thermal expansion and the biaxial modulus were measured by the thermally induced bending technique. The stress of the metallic films,deposited by thermal evaporation (Ag and Al), is tensile, while that of the amorphousfilmsdeposited by sputtering(a-Si:H, a-Ge:H, anda-GeC x :H) and by glow discharge(a-C:H)is compressive. We observed that the coefficient of thermal expansion of the tetrahedral amorphousthin films prepared in this work, as well as that of the films reported in literature, depend on the network strain. The CTE of tensile films is smaller than that of their corresponding crystalline semiconductors, but it is higher for compressive films. On the other hand, we found out that the elastic biaxial modulus of the amorphous and metallic films is systematically smaller than that of their crystalline counterparts. This behavior stands for other films reported in the literature that were prepared by different techniques and deposition conditions. These differences were attributed to the reduction of the coordination number and to the presence of defects, such as voids and dangling bonds, in amorphousfilms. On the other hand, columnar structure and microcrystallinity account for the reduced elasticity of the metallic films.